DFRobot Devastator Tank Treaded Tracked Robot Part 1 Assembly You may have seen a few pictures of Rex our bearded dragon on top of a Tank Treaded Robot in some of my other posts. In this post I will go though the initial assembly and build of the DFRobot Devastator Tank Treaded Tracked Robot (although …
DFRobot Devastator Tank Treaded Tracked Robot Part 1 Assembly Read More »
With Halloween only a few weeks away, I just had to get started on some related Maker projects! I recently purchased an Adafruit Metro (which is similar to an Arduino Metro) for the purposes of reloading the bootloader onto a corrupt Nano(for another project). *Disclaimer: Most if not all links on this page will be Affiliate …
Spooky Halloween ? Creepy Eyes ? Arduino & RGB LED Strip Read More »
ESP8266 Send DHT Temperature & Humidity Readings to MQTT & OLED Display I had an extra ESP8266 laying around (as we all should) and decided to create a Temperature & Humidity Sensor for my office. The Raspberry Pi I was previously using for this has since been repurposed into a tracked robot tasked with such …
ESP8266 Send DHT Temperature & Humidity to MQTT & OLED Display Read More »
IoT Temperature & Humidity to Initial State Using a Raspberry Pi & DHT22 I have a Raspberry Pi 3 running OpenHab located on my desk next to my iMac. Since I spend most of day here, I thought it would be good to get some Temperature & Humidity data reading. Right now I am sending …
IoT Temperature & Humidity to Initial State Using a Raspberry Pi & DHT22 Read More »
ESP8266 NodeMCU Relay WiFi Garage Door Opener with Blynk //July 21 2016 Cleaned Up and Updated Code – Added IP Address Display and WiFi Strength to Blynk App Recently, I purchased a Chamberlain MYQ Internet Gateway for my primary Garage Door. This only took about 20 minutes to get setup and now I had remote …
ESP8266 NodeMCU Relay WiFi Garage Door Opener with Blynk Read More »
